How do I check my routing table?

How do I check my routing table?

To display the local routing table:

  1. Open a command prompt.
  2. Type route print.
  3. Press Enter.
  4. Observe the active routes by destination, network mask, gateway, interface, and metric.
  5. Close the command prompt to complete this activity.

Which command displays the routing table in Windows?

The -r option of netstat displays the IP routing table.

What is Route command in CMD?

The route command allows you to make manual entries into the network routing tables. The route command distinguishes between routes to hosts and routes to networks by interpreting the network address of the Destination variable, which can be specified either by symbolic name or numeric address.

How do I view a persistent route in Windows?

To check your result type “route print” and it should be under “Persistent routes” section.

  1. To remove or to delete an entry, type this: “route -p delete 10.11.12.13”
  2. HKEY_LOCAL_MACHINE->SYSTEM->CurrentControlSet->
  3. ->Services->Tcpip->Parameters->PersistentRoutes.

How do I show a route table in Linux?

Using netstat command Netstat combined with the -r option will display the kernel routing tables. This is commonly used with the -n option, which will only show numerical addresses rather than performing any sort of name resolution.

How do I view a route table in Linux?

To display the kernel routing table, you can use any of the following methods:

  1. route. $ sudo route -n. Kernel IP routing table. Destination Gateway Genmask Flags Metric Ref Use Iface.
  2. netstat. $ netstat -rn. Kernel IP routing table.
  3. ip. $ ip route list. 192.168.0.0/24 dev eth0 proto kernel scope link src 192.168.0.103.

Which command will you use to see the available routes?

A user executes the following command successfully:$ chmod +x file1….

Q. Which command will you use to see the available routes?
C. netstat -r
D. none of the mentioned
Answer» c. netstat -r

Which of the following commands can be used to display or modify the routing table?

You can use the route command to modify the routing table.

How do you show routes?

Use the show ip route EXEC command to display the current state of the routing table….Sample Displays.

Field Description
Routing entry for 131.119.0.0 (mask 255.255.0.0) Network number and mask.
Known via “igrp 109” Indicates how the route was derived.

How do I display the routing table in packet Tracer?

Use the show ip route EXEC command to display the current state of the routing table.