How do you photograph glass marbles?

How do you photograph glass marbles?

You need to use a very LARGE light source, very close to the marble. The large source can be a large diffusor (typically, a lot larger than the roof of your light tent), with your lights on the other side/above. It’s not the amount of light that you’re fighting with, it’s the size of the light sources.

What materials can you use to capture a reflection photo?

Which materials have a reflective surface?

  • Metal – Any metal surface will reflect. Surfaces with less scratches are best.
  • Glass – Glass will also reflect.
  • Marble – Shiny smooth stone surfaces will reflect, but not as much as glass or metal.
  • Water – Where water forms a flat surface, there will be a reflection.

How do you photograph reflective plastic?

Shoot in manual mode and set your aperture to at least f/11, but preferably higher (like f/16). Use the lowest ISO possible, like ISO 100, to capture the most detail. Learn more about camera settings in our guide to DIY product photography.

How can we prevent glass reflection in photography?

Position your camera slightly higher than you would to light a backlit glass product so that you are shooting slightly down at your product. This will eliminate reflections and allow for a flattering angle of your product. And as always, make sure that your product has been cleaned thoroughly.

How do you photograph iridescent glass?

The way to photograph glass art is to use a Plexiglas Shooting Table as both the stand and the background. Place a light underneath facing upward to give a graduated lighting effect, then; use a circular polarizer to reduce the reflections.

How do you take pictures of glass objects?

Table of Contents

  1. Use Backlight to Combat Reflections.
  2. Create Backlight Without Fancy Equipment.
  3. Create Fake Reflections to Avoid Extra Work.
  4. Photograph Glass on a Black Background to Add Drama.
  5. Use Two Light Sources to Add Depth.
  6. Use a Long Focal Length to Make Shooting Easier.
  7. Clean the Glass to Avoid Smudges and Smears.

How do you photograph shiny objects?


  1. Diffuse the light. Use a light tent. Use diffuse paper.
  2. Tabletop photography. Use a low ISO and a small aperture. Use a tripod. Use a cable or remote release.
  3. Larger objects. Shoot during the golden hour or on an overcast day. Choose a setting without a lot of objects that will reflect in your subject.

How do you stop infrared reflection on glass?

Turning off the IR lights improves the picture even more. If you can’t push the camera onto the glass, try to angle it to offset the reflection. Even an angle of five degrees will help. Moving the reflection out of direct line of sight will clear up the picture enough so you can get by.