Why is my Mylaps transponder flashing red?

Why is my Mylaps transponder flashing red?

If the transponder is flashing red quickly (5 times per second), the subscription has expired. Please renew the subscription. When the LED of the transponder is flashing green, this means the battery is full.

How do I know if my Mylaps transponder is working?

Check if your Bluetooth is on and connected with the transponder….Before we can authorize to send your transponder back to MYLAPS, check your subscription.

1. A working transponder needs an activated subscription.
2. If there is no subscription or the subscription has not been activated, your transponder will not work.

Why is my transponder not working?

There can be a few reasons why your transponder isn’t working properly, such as: You ran out of funds in your account. Your transponder’s battery is running low. Your transponder is improperly mounted.

How do you charge a Mylaps transponder?

In the box of the TR2 transponder, you find a cable and a cradle. Place the cable in the cradle you can plug the cable in your computer/laptop or a general power plug. It takes 5 hours to fully charge the TR2 transponder. When the transponder is in the cradle, the LED will be steady green.

Do transponders expire?

If the transponder is not replaced within 45 days of the date on the letter, the transponder will be deactivated and continued use of that transponder will result in toll violations.

Do transponders have batteries?

The E-ZPass battery is sealed inside the transponder. You can’t replace the battery yourself, but it should last about a decade before you need to replace the transponder. There are more than 30 million transponders in use, and drivers in the Washington region get them from many different transportation agencies.

Why did my transponder key stop working?

Dead Batteries The most usual reason a transponder fails to work would be your battery. With every transponder key, there’s a little battery which aids the communication with the car. Although these batteries are made to endure for a while sometimes, they will fail and run out of juice.

How long does it take to charge a Mylaps transponder?

5 hours
It takes 5 hours to fully charge the TR2 transponder. When the transponder is in the cradle, the LED will be steady green. When the transponder is not in the cradle, the LED will blink green.

How do I charge Mylaps X2?

To charge the battery of your X2 transponder slide the X2 RaceKey onto the back of the transponder and have the RaceKey connected to a computer or USB adapter by USB-cable.

How do I activate my transponder in Mylaps?

Part 2: Activate the subscription on your transponder

1. Start MYLAPS Connect software and log in.
2. Connect your X2 RaceKey to your computer.
3. Follow instructions in MYLAPS Connect.
4. Connect your X2 RaceKey to your X2 Transponder or X2 RaceKey Mount.
5. Your license is transferred to your Transponder and you’re good to go!