How do you find the density of a steam table?

How do you find the density of a steam table?

Steam Density = k * P/T where k is a constant that is inversely proportionnal with static pressure and temperature. k = 1,3 approx. k = 1.2 approx. The trick is to set up a table (calculated from your steam tables) that represents k for different pressures and temperatures.

How hot is 150lb steam?

Gauge Pressure (psig) Temperature (oF) Enthalpy
Saturated Vapor (Btu/lb)
145 363 1195
150 366 1196
155 368 1196

How do you read a steam table?


  1. P = Pressure of the steam/water.
  2. T = Saturation point of steam/water (boiling point)
  3. vf = Specific volume of saturated water (liquid).
  4. vg = Specific volume of saturated steam (gas).
  5. hf = Specific enthalpy of saturated water (energy required to heat water from 0°C (32°F) to the boiling point)

How is steam quality calculated?

Steam quality is a measure of the amount of saturated steam that coexists with its condensate in a given system. Calculate it by dividing the mass of steam by the total mass of steam and condensate.

How do you find the density of superheated steam?

Calculate Superheated Steam Enthalpy and Density with new ‘Zpbe’ equation for Pressures 1 – 140 Bar and Temperatures 100 – 700 Degr. Celsius.

  1. Part I The three Equations.
  2. — 1 –The enthalpy of superheated steam can be calculated from:
  3. Hsteamsup = 1892 + 4.52 * Zpbe-h2o * R / MW * T ………(
  4. –2 –Density of superheated Steam:

What is steam table?

What Is a Steam Table? Steam tables are essentially countertop food warming systems, in which hot water uses the power of radiant heat to keep food at safe temperature levels. It’s important to note that these types of machines can come with different terminology attached.

What information can be found in steam tables?

These are pressure, temperature, sensible heat, latent heat, total heat and volume, remember these key areas and you’ll be reading steam tables in no time.

What is Hg in steam table?

hg is the value of enthalpy of saturated vapor. hfg = hg-hf = enthalpy change when substance goes from saturated liquid to saturated vapor which is actually latent heat of vaporisation.

How do you calculate steam requirements?

  1. ms: Mean rate of condensation of steam in kg/hr.
  2. W: Total weight of pipe plus flanges and fittings in kg.
  3. Ts: Steam temperature oC.
  4. Tamb: Ambient temperature.
  5. Cp: Specific heat of pipe material in kj/kgoC.
  6. hfg: Enthalpy of evaporation or saturated enthalpy at operating pressure in kj/kg.
  7. t: Time of warming-up in minutes.

What is steam purity?

Steam purity refers to the amount of solid, liquid, or vaporous contamination in the steam. High-purity steam contains very little contamination. Normally, steam purity is reported as the solids content.