What does the AUX button do on a Balboa hot tub?
Priming the Pumps Also, push the Pump 2 or “Aux” button, if you have a 2nd pump, to turn it on. The pumps will now be running in high-speed to facilitate priming. If the pumps have not primed after 2 minutes, and water is not flowing from the jets in the spa, do not allow the pumps to continue to run.
Why doesn’t my hot tub heat up?
Low flow in your spa or hot tub is most commonly associated with a dirty spa filter. If your spa heater won’t heat, remove and clean the filter(s) to rule out a pressure or flow rate problem. Low water level, a clogged pump impeller, closed valves, clogged pipes, or blocked spa drain covers can also cause flow issues.
How do I program my Balboa hot tub?
To program, press “Temp,” then “Jets 1.” Press “Temp” to adjust. Press “Jets 1” to exit programming. For non-circ systems, low-speed pump 1 and the ozone generator (if installed) run during filtration. For 24 hour circulation systems, the circ pump and the ozone generator (if installed) run 24 hours.
How do I unlock my TP600?
TP400W, TP500 and TP600 keypads : Since there are many locking options, we recommend that you refer to the user manual. To unlock the panel, while holding down the “Temperature” button (or the “Up” button if you do not have the “Temperature” button), gently press and release the “Light” button twice.
How do I get my Balboa hot tub out of sleep mode?
On screen it will just state rest mode or whilst running filteration it will state “run” “pump” “for” “temp”. TO EXIT REST MODE:- Press Temp, then press light repeatedly until ‘MODE’ appears in the LCD. Toggle between READY and REST by pressing temp.
What mode should my hot tub be in?
By default filter modes are 2 hours in the morning and 2 hours in the evening, the rest of the time the hot tub will use the insulation to keep the spa warm and retain heat. Economy is a good setting for those who use the hot tub daily.
How do I reset my Balboa hot tub control panel?
Remove the spa cover and allow water to cool. At 107¡F (approximately 41.7¡C), the spa should automatically reset. If spa does not reset, shut off the power to the spa.
How long does it take a Balboa hot tub to heat up?
It will take less time to heat if it is warmer outside. If you want your hot tub to be 100 degrees, it will take 4 hours to reach it’s temperature. If you keep your hot tub cover on, you can shorten that time.