How do I reset my Epson ink cartridge without Resetter?
Hey, you can reset Epson ink cartridge without resetter! As shown above, you can reset Epson chips by pressing and holding the button above the chip with a bent paper clip for 10 seconds.
Where is the reset button on an Epson ink cartridge?
Turn the ink cartridge to where the microchip can be found. Using the end of a paper clip, press the reset button that can be located above the metal contacts, right in the center.
How do I reset my Epson ink cartridges after refilling?
Press the up or down arrow button to select Setup > Maintenance > Reset Ink Levels. Press one of the Start buttons, then press the OK button. Press the OK button again. Press the right or left arrow button to highlight the ink tank you refilled, and press the OK button to select it.
How do I Reset my Epson cartridge chip?
You can use a paper clip to reset your Epson cartridge chip if there’s a single pinhole on the small green microchip on the bottom or side of the cartridge. If there are two round metal contacts at the top or bottom of the chip, you’ll actually need two paperclips. If you have a cluster of 7 to 9 pinholes instead, see this method.
How do I reset the ink cartridge to default settings?
Press the pins on the reset tool firmly against the chip contacts on the ink cartridge until the light on the reset tool begins to blink red. This will indicate that the reset tool has recognized and is connected to the ink cartridge.
How do I use the cartridge reset tool?
Press the pins on the reset tool firmly into the chip contact holes. The LED on the cartridge tool may blink several times to indicate that a connection is being made. This depends on the reset tool you purchased.
How do I Configure my Epson printer on the Revel network?
Configuring the Printer. On an iPad or computer connected to the Revel network, open Safari or a web browser. Enter the printer’s IP address and tap Go. The next page will direct you to enter the login credentials. Enter the following: Username: epson. Password: epson. In the Configuration menu, navigate to TCP/IP.