What are the tines of a forklift?

What are the tines of a forklift?

Forklift forks, also known as tines or blades, are used to lift and carry loads. They are an integral part of the forklift and ensuring you are using the correct ones and that they are in good condition is essential to both the safety of personnel, but also the forklift and the load.

What are the OSHA regulations for forklift?

OSHA 29 CFR 1910.178(I) requires that employers provide forklift operators training for vehicle inspection and maintenance. Operators must be over 18 years of age and be recertified at least once every three years. The similar CSA standard is B335-04 (R2012).

How do you move a forklift tine?

Raise the fork slightly. The fork will be resting in a small groove in the crossbar; nudge the fork out of the notch so that it will slide along the top of the crossbar. If the forks are rarely adjusted they may be very hard to move. If so, move to the end of the fork and move it from side to side to break it free.

What does OSHA say about rigging?

Rigging equipment for material handling shall be inspected prior to use on each shift and as necessary during its use to ensure that it is safe. Defective rigging equipment shall be removed from service. Not be used without affixed, legible identification markings, required by paragraph (a)(2)(i) of this section.

Is rigging considered a suspended load?

Essentially, anything that is lifted above ground is considered a suspended load. You’ll find such loads on riggings, slings, pallets, and various pieces of equipment.

What do you call the prongs on a forklift?

Forks, Also known as the tynes, the forks on a forklift are used to make direct contact with a load for transport. They are attached to the forklift carriage and are designed to carry a load from the bottom.

What is an outrigger on a forklift?

Outriggers keep your truck stable during any kind of lift by extending outward and making contact with the ground several feet away from the truck. This provides a solid, stable base by distributing the crane’s load over a larger area. Types of outriggers. There are two primary styles of hydraulic outriggers.

How should you mount and dismount a forklift?

When mounting or dismounting a forklift, always:

  1. Face the vehicle.
  2. Never jump off.
  3. Use a three-point stance (always have both hands and one foot or vice-versa in contact with the unit)
  4. Wear certified safety shoes (oil resistant and non-slippery)
  5. Wear suitable clothing (do not wear loose clothing or dangling jewelry)

What is the correct fork position when picking up a load?

Carrying the load Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground. Remember that forklifts are top-heavy. Carry the load low and tilted back. Use caution when carrying a load on an uneven surface; it creates a tip-over hazard.

Where should the forks or load be positioned while driving a loaded forklift?

drive with the fork arms as close to the ground as reasonably practicable, with the tips of the fork arms tilted slightly upwards and away from the ground, whether driving with or without a load.