How much does a Honda Civic computer cost?

The best part is, our Honda Civic Engine Computer products start from as little as $248.99.

How do you reset the ECM on a 2008 Honda Civic?

Re: how do you properly reset the ecu

drive car til its warmed up.
turn car off, disconnect battery or pull FI ECU fuse out.
put fuse back, start car, close hood.
make sure all accessories are off, do not press any gas or brake.
just let the car idle for 10 mins by itself.

Where is the PCM located in a Honda Civic?

In most vehicles, the PCM is in the engine bay, but a few manufacturers place the PCM inside the vehicle. In some vehicles, the PCM is even located in the trunk. Once the PCM has been located, any obstructions to testing and replacement must be removed, and testing begins.

How much does it cost to replace an ECU Honda Civic?

ECU repairs can be very expensive. The part alone can cost between $1,000 and $3,000, depending on the make and model of your vehicle.

How do I identify my Honda ECU?

– All Honda ECU’s have an ECU part number which is located on the side of the ECU which allows for easy identification. The middle three characters are the most useful to identify what type of ECU it is. Different generation ECUs may use the same characters.

How do I use OBD scanner?

Here’s a simple step-by-step guide:

Step 1: Locate The Diagnostic Link Connector.
Step 2: Connect Your OBD2 Code Reader Or Scanner To The DLC.
Step 3: Enter The Information Requested On The Scanner Screen.
Step 4: Access The Scanner Menu For OBD Codes.
Step 5: Identify And Understand the OBD Codes.

What is an OBD port?

The On-Board Diagnostics II (OBD-II) port is used to access the vehicle’s computer for various tasks, such as emissions tests and diagnostics. The OBD-II port is where the Hum System is installed so that the network can communicate with the vehicle directly.

How do you know if your ECU is bad?

Here are the most common symptoms of a bad ECU:

Check Engine Light stays on after resetting.
Car was jump started on reverse polarity.
Engine turning off for no reason.
Water Damage or Fire Damage on the ECU.
Apparent loss of spark.
Apparent loss of injection pulse or fuel pump.
Intermittent starting problems.
Overheating ECU.

What is PCM failure?

symptoms of wear or failure of the pcm (powertrain control module) check engine light illuminates with codes that cannot be repaired are stored. when the pcm detects an issue, but no issue exists, the pcm may have failed, and is reading erroneously. several unrelated trouble codes are set simultaneously.